Breaker Keeps Tripping? What to Check First

A breaker (called an MCB in India) trips to protect wiring from too much current: usually an overloaded circuit, a faulty appliance or a short circuit. Unplug everything on that circuit, switch the breaker fully off and back on, then plug appliances back in one at a time.

If it trips with nothing plugged in, or you notice burning smells or scorch marks, stop and call an electrician.

By , maker of TalkFixAI · Published

Find the circuit, then find the culprit

  1. Step 1: Find the tripped breaker

    Open the distribution board or breaker panel door. A tripped breaker sits in the middle position or fully off (on most Indian MCBs, the lever points down). Read the label next to it to see which room or appliance it supplies.

  2. Step 2: Unplug everything on that circuit

    Switch off and unplug appliances in the rooms the breaker supplies, especially high-power ones: heaters, geysers/water heaters, irons, kettles, microwaves and ACs. This removes the load so you can tell whether the problem is an appliance or the wiring.

  3. Step 3: Reset the breaker fully off, then on

    Push the lever firmly to fully off first, then to on. Many breakers will not reset straight from the middle position. If it trips again immediately with everything unplugged, leave it off and call an electrician: the fault is likely in the wiring, a switch or a fixed appliance.

  4. Step 4: Add appliances back one at a time

    Plug in and switch on one appliance, wait a minute, then add the next. If the breaker trips as soon as one particular appliance turns on, that appliance is the likely cause. Stop using it and have it checked.

  5. Step 5: Spread out heavy loads

    If it only trips when several high-power appliances run together, the circuit is overloaded. Move one of them to a different circuit, or run them at different times. A circuit that needs more capacity is a job for an electrician.

Overload, short circuit or earth leakage?

  • Overload: the breaker trips after the circuit has been running for a while, usually when a heater, iron or AC switches on alongside other devices.
  • Short circuit: the breaker trips instantly, sometimes with a pop or spark. This is often a damaged cable, plug or appliance.
  • Earth leakage or ground fault: an RCCB/ELCB (India) or GFCI (US) trips, often in a bathroom, kitchen or outdoor circuit, or after rain. Current is leaking where it should not. These devices protect people from electric shock, so repeated trips need an electrician.

Write it down for the electrician

Note which breaker trips, how long after resetting, which appliance was running and whether the weather was wet. That record helps an electrician find the fault faster.

Signs it is a job for a licensed electrician

Call a licensed electrician if:

  • the breaker trips again with nothing plugged in,
  • you smell burning, see scorch marks or the panel feels warm,
  • an RCCB/ELCB, GFCI or AFCI keeps tripping,
  • a breaker will not stay on or feels loose,
  • trips happen after rain or near water.

Do not open the panel or replace breakers yourself.

Questions about breakers and MCBs

Why does my breaker keep tripping?

The three usual causes are too many appliances on one circuit (overload), a faulty appliance or cable (short circuit), and current leaking to earth (ground fault). The step-by-step check above narrows down which one you have.

Is it safe to keep resetting a tripping breaker?

Resetting once after unplugging the circuit is reasonable. Resetting repeatedly without finding the cause is not: the breaker is warning you about a problem that can overheat wiring.

What is the difference between an MCB and an RCCB?

An MCB trips on overload or short circuit to protect wiring. An RCCB (or ELCB) trips when current leaks to earth, to protect people from electric shock. In the US, the equivalent shock protection is usually a GFCI outlet or breaker.

Can a bad appliance make the breaker trip?

Yes. If the breaker trips as soon as one appliance is switched on, that appliance or its cable is the likely cause. Stop using it until it has been checked.

Why does the breaker trip when it rains?

Moisture in outdoor sockets, lights or cable joints can cause earth leakage. Keep away from wet electrical fittings and ask an electrician to inspect them.

Checked against: Ameren: Electric safety tips.

How TalkFixAI talks you through a fix

The screens below illustrate a TalkFixAI conversation that follows the steps in this guide. Your own conversation will depend on what you describe.

  1. Illustrated TalkFixAI chat. You: “The MCB for the kitchen keeps tripping.” TalkFixAI: “First, unplug everything on that circuit, especially the kettle, microwave and geyser. Do you smell burning or see scorch marks?”
    Step 1Breaker keeps tripping?Find the cause without guessing.
  2. Illustrated TalkFixAI chat. You: “No smell. Everything is unplugged.” TalkFixAI: “Push the switch fully off, then on. Does it stay on?”
    Step 2One appliance at a time.Narrow it down safely.
  3. Illustrated TalkFixAI chat. You: “What if it trips with nothing plugged in?” TalkFixAI: “Then leave it off and call an electrician. The fault is likely in the wiring or a fixed appliance.”
    Step 3Know when to stop.Some faults need an electrician.

Want TalkFixAI to talk you through this repair hands-free while your hands are busy? Try TalkFixAI, the free repair assistant that answers by voice, even offline.

Other electrical problems